1.Welcome to our website,hope we can be the key business partner in the near future.
- Phone: +86-020-31606393
- E-mail: firstname.lastname@example.org
- Fax: +86-020-31606393
Antique brick paving the first step: "determine the program." Commonly used antique brick paving methods, in addition to the same as the traditional wall tiles in the middle, vertical and horizontal paving method, the antique brick, there are "herringbone", "I-posted", "ramp-shaped Ling "Line" corner brick lining small tile paving, floor tiles with sideline paving, etc., can be described as a variety of paving ways, each with its advantages. Working with designers to choose a suitable way of paving relates to buying, counting, etc., can not be taken lightly.
The second step of the antique brick tile: "leveling." The so-called leveling means that before paving the antique tiles, the surface of the building to be paved should be treated, such as the interior wall surface, exterior wall surface, and the ground, to remove the dirt attached to the surface, and sprinkle water to moisten it, and then mix and level it with cement and sand. , The general use of a gray shovel on the surface of the non-stop application to keep the cement floor level, until the cement mixture is completely dry before paving.
Antique brick paving the third step: "bomb line." This line is the use of a long thin line, according to the determined way of paving, online painted with color or white ash, and then in the leveling of the floor to draw the location of antique tiles and brick seam reference line. It's a good idea to use a black line with a carpenter on a board.
The fourth step of the antique brick paving is "paving". After doing the above preparations, we must really start the work of tiling. Pay attention to whether the construction team's construction methods are detailed and can greatly reduce the decoration problems that will occur in the future.
Antique brick paving the fifth step: "impregnated brick." The matt bricks are soaked in clean water so as not to generate bubbles, so that the tiles can fully absorb moisture and prevent the dry tiles from reabsorbing water after the completion of the decoration to cause deformation of the tiles.
Antique tiles posted the sixth step: "mixed pulp." Cement mortar should be mixed in a ratio of 1:2. The cement mortar number after mixing should be below 200#. These will be used to smear on the back of the tile.
Antique brick paving the seventh step: "spray". Take out the soaked tiles, dry the water stains, spray enough water on the screed, then evenly apply the cement mortar on the back of the brick. The thickness of the mortar is 5~6cm. It is appropriate to thicken the large-size matt bricks. Immediately after the bricks were affixed, gently beat with a wooden hammer to prevent formation of empty drums, and use a ruler at any time to level.
Antique tile paving the eighth step: "dressing". After filling a certain area, the joints are used to fill and smooth the brick joints. Finally, the brick surface dirt, such as cement mortar, sewage, stains, etc., shall be removed to strengthen the care.